Skip to content
Cold Air Conditioning Austin Call(737) 239-8011

Drain Line Cleaning in Austin, TX

We clear clogged condensate drain lines and trace water around Austin air handlers.

A technician standing with arms folded on a driveway in front of a service van with a ladder on its roof, a condenser unit beside the house

Water at the air-handler closet and water dripping from a ceiling can both get called an AC leak, but they point to different drain faults. A wet threshold beside the indoor unit often points to a backed-up condensate line or a tripped float switch. A ceiling stain below the unit can point to an overflowing secondary pan, a loose drain fitting, or a condensate pump that has stopped moving water.

We handle both the blocked line and the pan, pump, or connection fault that lets condensate escape. We cover Austin, Rollingwood, West Lake Hills, and Lost Creek from our location on Amberglen Blvd.

This isn’t work to put off when water is present. The cooling cycle keeps making condensate, so a full pan or blocked line can keep soaking drywall, flooring, and the air-handler cabinet.

Water by the unit and ceiling drips

You might see water pooling beside the indoor unit, a drip from a ceiling vent, or a rust-colored stain below an attic air handler. Some people notice the system turns off even though the thermostat still calls for cooling. Others report a musty smell from the closet or water at the end of the PVC drain outside.

A full drain pan, a blocked trap, a failed condensate pump, and a loose fitting can all leave water in similar places. We need to look at the pan, float switch, drain route, and outlet because those faults use different parts and require different repairs.

Condensate drain inspection

We start by checking the primary pan, secondary pan, float switch, drain trap, cleanout, and the drain outlet. We look for algae buildup, loose PVC joints, crushed vinyl tubing, and water marks around the air handler. Where the pipe is accessible, we measure the drain diameter and visible route to the outlet.

We test the line with water and use the cleanout or outlet to clear buildup from the pipe. A basic inspection and flush can take about 15 to 30 minutes when the trap and drain route are accessible. We can replace an accessible trap, float switch, fitting, tube, or pump when the correct part is available. A concealed pipe run, damaged ceiling section, or part that must be ordered is usually booked for another visit.

PVC route, ceiling access, condensate pump

An exposed PVC drain with an open cleanout is usually simpler to test than a line behind drywall or above a finished ceiling. A drain route through an attic can also take more work when insulation, framing, or a tight platform limits access to the air handler.

The age and condition of the trap, pump, pan, and glued fittings matter too. Older PVC joints can crack when they are opened, and a pump or float switch may need replacement instead of cleaning. If a specific pump, pan, or fitting has to be ordered, that changes the work involved.

Air handler label and drain exit

Before you call, look for the data plate on the air handler or inside the access panel. The model number is usually printed on that label and helps us identify the float switch, pump, and pan setup. Tell us which room has the unit and where you see the water.

Let us know whether water is still running from the PVC outlet outside or whether the drain pan is full. If the air handler is in an attic, closet, or garage, describe the access hatch, platform, or door. Call us at (737) 239-8011 before standing condensate overflows the pan and reaches the ceiling or floor.

When we are open

  • Monday Open 24 hours
  • Tuesday Open 24 hours
  • Wednesday Open 24 hours
  • Thursday Open 24 hours
  • Friday Open 24 hours
  • Saturday Open 24 hours
  • Sunday Open 24 hours

Next

Next: air duct repair, or back to the home page.