Skip to content
Cold Air Conditioning Austin Call(737) 239-8011

Air Conditioner Repair in Austin, TX

We repair AC units with warm air, leaks, noises, and electrical faults.

A technician standing with arms folded beside an outdoor condenser unit at the side of a house, a mown lawn running away behind her

Warm air from the vents, a clicking condenser, a burning smell, or a damp patch near the indoor unit can show up without warning. We find the fault behind the symptom instead of replacing a part based on the sound alone.

Your thermostat, electrical disconnect, capacitor, contactor, condenser fan, and refrigerant circuit can all affect cooling. A unit may still run while one of those parts is failing, but repeated cycling and poor airflow can put more strain on the compressor.

A new burning smell, a tripped breaker, or an outdoor unit that will not start should not wait because electrical damage can spread through the wiring and controls. If the system cools normally but your bill has climbed, we can inspect the equipment before a smaller fault becomes a shutdown.

Warm vents and clicking units

You may have an AC that runs all day but sends warm air through the supply vents. You might hear clicking at the outdoor unit, hear a hum with no fan movement, or find that the thermostat screen is blank. Some people notice the breaker trips when cooling starts, while others smell hot plastic near the air handler or condenser.

A frozen refrigerant line, weak airflow from one room, and water around the indoor cabinet can also point to an AC problem. These signs can overlap, but a failed capacitor, a loose wire, a thermostat issue, and a refrigerant fault are separate repairs with different parts and different costs.

Condenser diagnostic visit

We start at the thermostat and then check the indoor air handler, breaker, disconnect, wiring, filter condition, and outdoor condenser. A multimeter lets us check voltage, amperage, and the capacitor rating, while gauges are used when the refrigerant circuit needs testing.

The initial checks and meter readings generally take 30 to 60 minutes when the equipment is accessible. A failed fuse, capacitor, contactor, or thermostat battery can often be replaced during the visit when the matching part is available. A control board, compressor issue, or refrigerant leak may need a follow-up visit for part ordering or leak testing.

Capacitor age and condenser access

The part causing the failure matters. A capacitor or contactor is a different repair from a damaged control board, failed condenser fan motor, or compressor problem. Older equipment can also use parts that are no longer stocked locally and must be ordered by model number.

Access changes the work as well. A condenser behind a locked gate, on a roof, or in a tight side yard takes more setup than a unit beside an open driveway. Corroded disconnects, brittle wiring, and a refrigerant leak that must be located can also add work beyond replacing one failed component.

Model number and unit location

Have the model number from the rating plate ready if you can find it. The plate is usually on the side of the outdoor condenser or inside the panel area of the indoor air handler.

Tell us which rooms have warm vents and whether the condenser is running now. It also helps to know the approximate age of the system, whether the breaker has tripped, and how we can reach the outdoor unit.

Call Cold Air Conditioning Austin at (737) 239-8011 if the condenser keeps clicking or cycling without cooling, because repeated starts can overheat the compressor.

When we are open

  • Monday Open 24 hours
  • Tuesday Open 24 hours
  • Wednesday Open 24 hours
  • Thursday Open 24 hours
  • Friday Open 24 hours
  • Saturday Open 24 hours
  • Sunday Open 24 hours

Next

Next: drain line cleaning, or back to the home page.